Glass Tempering Insights: Latest News

fault lies, reasonable repair and exclude, to avoid damage and safety incidents.1. Fan vibration is too large1.1. The impeller is excessive dust, overdose dirt, corrosion or war and tear caused by balance lapsed.1.2. The impeller and the volute or duct contact deformation.1.3. Loose rivets connectin

When using a tempering furnace to produce various types of glass, you should pay attention to the following five points:1. When tempering glass with holes and grooves, the heating time should be increased by 2.5%-5% compared with glass without holes and grooves of the same specification.2. When temp

How to calculate the length of Kevlar Ropes required for the glass tempering furnace' rollers? Gap winding method: a. The diameter of the steel shaft x 3.14 x the number of turns of the aramid rope around a roller b. The number of turns of a roller kevlar rope = total length/the center dis

China Shanghai International Glass Industry Technology Exhibition (China Glass) has been held at the Shanghai New International Expo Center from April 25 to 28, 2024. This exhibition covers the entire industrial chain of the glass industry, including: glass production technology and equipment, glass

First checks which we made was made on hot furnace:1. Blowers of convection, does it work right hZ, does it switch on/off on right time of the cycle. Everything works fine.2. Heaters. Resistance and load of each heater. Everything is ok.3. SSR which are switching ON/OFF heaters. It works fine.4. Tem

Is it necessary to choose top and bottom force convection system for glass tempering furnace?Not necessaryForce convection system is mainly used to temper the coating glass, especially for procesing Low-e glass.because there is one coating layer for coating glass, and this coating layer is upper sur

Tempered glass mainly uses physical or chemical methods to form a compressive stress layer on the surface of the glass and a tensile stress layer inside. Just like everything else, the quality of a product is closely related to the production equipment. Only when the production equipment is in good

For the problem of white haze caused by ceramic roller, normally, you can try to solve it by following way: 1.Maybe the ceramic roller is dirty, pls clean the ceramic roller2.The bottom heating temperature is high, pls reduce the heating temperature for bottom little3.You know, there is one thermal/